HS-955 Carbon Steel Cowboy Bull Cutter Knife – Oil Tempered, Custom Leather Sheath

Oil Tempered Carbon Steel – Cowboy Bull Cutter That Holds Its Edge

The HS-955 is a carbon steel cowboy bull cutter built around one priority: edge performance. Carbon steel at 58–60 HRC, oil tempered and hand forged, produces a blade that cuts cleanly, holds that edge through sustained work, and comes back sharp faster than most alloys when it finally needs attention.

Six inches overall. 2.75-inch blade, 3.25-inch handle. Full tang. Sharpened at 20 degrees and ready to use from the first day. The custom leather sheath keeps the blade protected and the knife accessible on the belt.

Specifications

Oil Tempering – What It Does to the Steel

Oil tempering is a heat treatment process where the blade is heated to critical temperature and then quenched in oil rather than water. The oil quench cools the steel at a controlled rate, reducing internal stress and producing a blade that is tough as well as hard. At 58–60 HRC, the HS-955 sits in the range where a working carbon steel blade performs best — sharp, durable, and field-serviceable.

Handmade – Each Piece Is Individual

Because this knife is hand forged, minor variations in handle color and sheath finish are normal and expected. No two pieces are identical. The blade geometry, steel, and construction are consistent — the surface details reflect the handmade process. This is not a flaw; it is what separates a hand forged knife from a factory product.

What's Included

• HS-955 Carbon Steel Cowboy Bull Cutter Knife
• Custom original leather sheath
• Sharpener

Knife Care

• Wipe the blade dry after every use — carbon steel develops surface rust quickly if left wet
• Apply a light coat of mineral oil after cleaning
• Store in the leather sheath in a dry location
• Resharpen at 20 degrees on a whetstone — carbon steel responds quickly

Frequently Asked Questions

Why does the listing say handle and sheath color may vary?
Each knife is hand forged individually. Minor variations in handle tone and leather finish are a natural result of the handmade process. The blade, steel, and construction are consistent across all pieces.

How often does carbon steel need to be oiled?
A light coat of mineral oil after cleaning is enough. For knives stored long-term, re-oil every few months. For daily-use knives, a quick wipe after use is sufficient.

Is 58–60 HRC appropriate for a working bull cutter?
Yes. This hardness range is the standard for quality working blades. It holds an edge through sustained use and is easy to resharpen without specialized equipment.

Can this knife be used in wet outdoor conditions?
Yes, with basic care. Wipe the blade dry after exposure to moisture and apply a light oil coat. Carbon steel performs well outdoors when maintained properly.

Legal Disclaimer: This knife is intended for adults aged 18 and older. By purchasing this product, you confirm you are of legal age in your jurisdiction. Always check local laws regarding the purchase and carry of fixed blade knives before ordering. The buyer assumes full responsibility for compliance with all applicable laws.